Bug #35042
closed
Katello 4.4.1 fails to install on el8 because of jinja3 3.0 depedency
Description
Description of problem:
Katello 4.4.1 (foreman 3.2.1) fails to install on el8 because of a jinja3 3.0 dependency. This isn't even available in centos8 stream.
Steps to reproduce:
run "foreman-installer --scenario katello --foreman-initial-organization org --foreman-initial-location loc --foreman-initial-admin-username admin --foreman-initial-admin-password password"
Actual results:
Installer fails: several pulpcore-manager steps returned 1 instead of one of [0] - see attached log
Expected results:
Installer runs successfully.
Additional info:
It has been tested on Rocky Linux 8.6, fully updated on 20220609.
Output of the install command, and an relevant extract of the /var/log/foreman-installer/katello.log can be found attached.
The exact same install procedure was working on a fully updated Rocky Linux on 20220331 with foreman 3.2.0 and katello 4.4.0.
Files
Updated by Benjamin Hunt almost 2 years ago
- Priority changed from High to Normal
Updated by Benjamin Hunt almost 2 years ago
- Status changed from New to Resolved
- Priority changed from Normal to Low
I've tested this again on a blank updated system, and it works.
It looks like jinja2 got installed out of appstream instead of pulpcore, appstream repo had a higher priority.
Updated by William Clark almost 2 years ago
- Target version set to Katello Recycle Bin
- Fixed in Releases Katello Recycle Bin added