BMC » History » Revision 4
Revision 3 (Romain Vrignaud, 07/04/2013 09:23 AM) → Revision 4/7 (Romain Vrignaud, 07/04/2013 10:01 AM)
h1. BMC h2. HP iLO 3 and higher support To use foreman BMC support with ilo 3 and higher, the following iLO settings are required * an ilo user with administrator rights. Just giving the user "Virtual Power and Reset" rights does not seem to be enough * enable IPMI - Administration -> Access Settings -> Enable IPMI/DCMI over LAN on Port 623 after this you can verify access by running ipmitool: <pre> ipmitool power status -H <iLO ip-address> -U <user> -I lanplus Password: Chassis Power is on </pre> h2. Dell DRAC To configure ipmi from commandline : <pre> # ipmitool lan set 1 ipaddr your_ip # ipmitool lan set 1 netmask your_netmask # ipmitool lan set 1 defgw ipaddr your_default_gw # ipmitool lan set 1 access on # ipmitool user set name 3 foreman # ipmitool user set password 3 your_password # ipmitool channel setaccess 1 3 callin=on ipmi=on link=on privilege=4 </pre>