BMC » History » Revision 6
Revision 5 (Felix Barbeira, 07/12/2013 06:48 AM) → Revision 6/7 (Felix Barbeira, 07/12/2013 07:39 AM)
h1. BMC
h2. HP iLO 3 and higher support
To use foreman BMC support with ilo 3 and higher, the following iLO settings are required
* an ilo user with administrator rights. Just giving the user "Virtual Power and Reset" rights does not seem to be enough
* enable IPMI
- Administration -> Access Settings -> Enable IPMI/DCMI over LAN on Port 623
after this you can verify access by running ipmitool:
<pre>
ipmitool power status -H <iLO ip-address> -U <user> -I lanplus
Password:
Chassis Power is on
</pre>
h2. Dell DRAC
To configure ipmi from commandline :
<pre>
# ipmitool lan set 1 ipaddr your_ip
# ipmitool lan set 1 netmask your_netmask
# ipmitool lan set 1 defgw ipaddr your_default_gw
# ipmitool lan set 1 access on
# ipmitool user set name 3 foreman
# ipmitool user set password 3 your_password
# ipmitool channel setaccess 1 3 callin=on ipmi=on link=on privilege=4
# ipmitool user enable 3
</pre>